PROBLEM
POSSIBLE CAUSE
WATER LEAKS
●
Make sure hose connections are tight at faucets.
●
Make sure
of drain hose is correctly inserted and secured drain facility.
WASHER IS NOISY
●
Make sure washer is level and firm to
floor with rubber foot
in
and
front jam nuts tight. See your Installation Instructions.
- -
●
A sharp, distinctive sound
be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in.” This sound is normal.
●
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases (usually occurs
when washing a single, heavy item or a small load when water level is set higher
necessary), the
basket may strike the outer tub, creating a loud but
noise.
To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and
redistribute the load
about the wash basket. Close the lid and restart.
WASHER PAUSES
●
Washer normally pauses between washing steps... such as between wash and spin or
IN CYCLE
between spin and rinse.
If you need more
toll free: GE Answer Center
@
/ 800.626.2000/consumer information service
USER MAINTENANCE INSTRUCTIONS
The
The porcelain is self-cleaning. Leave lid
To Store Washer. Ask service technician to remove
open after washing to allow moisture to evaporate.
water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior.
Wipe off any spills of washing
to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations.
Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
How to remove the
—
For model
To remove the agitator,
snap the cap off and
remove the screw. Then remove the agitator
— Cap
extender (on models so equipped) and the agitator.
To replace the agitator,
carefully lower it
Screw
Agitator
Extender
straight
down onto the shaft so that it fits snugly
into place. Replace the agitator extender (on
models so equipped), the screw and the cap.
NOTE:
On models with HANDWASH System the
small HANDWASH agitator cannot be removed.
(on some models)
— Agitator
—
(Appearance may
23
