GE WA8610S, Use And Care Manual, Page: 21 / 24

PROBLEM POSSIBLE CAUSE
WASHER IS NOISY
●
Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Instructions.
●
A sharp, distinctive sound will be heard at the end of each spin period as the motor
.
stops the spin brake inside the transmission “locks sound is normal.
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases (usually occurs
when washing a single, heavy item or a small load when water
is set higher than
necessary), the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and
redistribute the load evenly about the wash basket. Close the lid and restart.
I
WASHER PAUSES
●
Washer normally pauses between washing steps... such as between wash and spin or
IN CYCLE between spin and rinse.
If you need more toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
USER MAINTENANCE INSTRUCTIONS
The Tub. The porcelain is self-cleaning. Leave lid To Store Washer.
Ask service technician to remove
open after washing to moisture to evaporate. water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior. Wipe off any of washing to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations. Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
How to remove the agitator To remove limestone from pan
To remove the agitator,
—
(on models so equipped)
snap the cap off and
remove the screw.
Then remove the
—
Agitator
●
Soak filter pan in a preheated
(71 ‘C.)
Extender
solution of half vinegar and half water for 15
agitator extender (on
models so equipped)
and the agitator.
(on some models)
minutes. Then brush each side of pan with a stiff
bristle brush while flushing with running water.
— Agitator
To replace the
agitator, carefully
.
,..
lower it straight down
onto the shaft so that it
fits snugly into place.
Replace the agitator
—
extender (on models
(Appearance may vary)
so
equipped), the
screw and the cap.
CAUTIONS:
●
Do not soak in porcelain container. Vinegar can
damage porcelain.
Do not exceed ) or filter pan
may warp.
21