GE Vivid S5 N, Service Manual

Page: 538 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
8-12 Section 8-2 - Cover Replacement Procedures
P R E L I M I N A R Y
8-2-4 Right Rear Cover Replacement Procedures
(cont’d)
8.) Pull the cover towards you and remove from the system.
8-2-4-4 Right Rear Cover Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the movie clip
previously referenced in the
Right Rear Cover Removal Procedure .
1) Return the right rear cover to its original position at the rear of the main assembly frame, taking care
to tilt it sufficiently so that the lower portion overlaps the system chassis on the right side - refer to
Figure 8-13 on page 8-12 .
2) Make sure the cover is properly aligned with the main assembly frame then push the cover
downwards to secure it in position.
3) Return the screw (previously removed) to the securing tab on the inner right side of the cover and
tighten securely - refer to Figure 8-11 on page 8-11 .
4) Return the screw (previously removed) to the top bracket of the cover and tighten securely (refer to
Figure 8-11 ).
5) Return the Basket (as described in the “Basket Installation Procedure” on page 8-20 ) and/or the
Tray (as described in the “Tray Installation Procedure” on page 8-22 ), as applicable.
6) Install the right side cover, as described in the “Right Side Cover Installation Procedure” on page 8-5 .
7) Install the front cover, as described in “Front Cover Installation Procedure” on page 8-19 .
8) Reconnect any peripherals previously connected to the system.
9.) Proceed to perform the following functionality tests:
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
Figure 8-13 Removing the Right Rear Cover