GE Vivid S5 N, Service Manual, Page: 474 / 834

GE
P
ART
N
UMBER
FN091065, R
EVISION
2 VS5 N
AND
VS6 N
S
ERVICE
M
ANUAL
7-90 Section 7-5 - Monitoring Tests
P R E L I M I N A R Y
Section 7-5
Monitoring Tests
7-5-1 Accessing the Monitoring Diagnostic Test Options
• Access the Diagnostic Test window, as described in the 7-4-1 "Accessing the Front End Diagnostic
Options" on page 7-27 .
7-5-1-1 Full System Monitoring Test
NOTE: For a description of this test, refer to the information in “Full System Monitoring Test” on page 7-15 .
1.) In the Diagnostic Test window, trackball to Full System Monitoring Test in the list of Monitoring
tests available for selection from the Diagnostic Test Tree (see Figure 7-58 "Full System Monitoring
Test" on page 7-90 ) and press Set . The Full System Monitoring Test name is displayed under
Execute; all system components to be tested are highlighted light blue in the Schematic View, as
shown below:
2.) As indicated in the Special Instructions area, disconnect any probes currently connected to the
system and make sure that nothing is touching the probe connectors.
3.) Under the Special Instructions area, activate the Loops checkbox
and select the required number of Loops from the combo box.
4.) Adjacent to On Fail, select either Stop or Continue , as required.
Stopping on failure enables you to review a failed test, the moment it fails. Alternatively, you may
prefer testing to continue on failure and later you may review the report.
5.) Trackball to the Start button and press Set .
NOTICE
In order to access an individual board test, it is necessary to insert the service dongle from system boot-
up and enter the Service Password.
Figure 7-58 Full System Monitoring Test