GE Vivid E9, Service Manual

Page: 338 / 802

GE H
EALTHCARE
D
IRECTION
GA091568, R
EVISION
5 VIVID E9 S
ERVICE
M
ANUAL
8 - 4 Section 8-2 - Warnings and important information
8-2-5 Tools needed for servicing VIVID E9
Table 8-1 Tools used for servicing VIVID E9
ITEM NO. TOOL SIZE TORQUE COMMENTS
1.
BIT # TX-10 M2.5
• Use Torque specified in procedure.
• If the torque is not indicated with the
procedure, hand tighten the screws/
nuts.
• 90 degree “L“ are suggested.
• A full set of 90 degree “L“ Torx
wrenches are recommended.
2.
BIT # TX-15 M3
3.
BIT # TX-20 M4
4.
BIT # TX-25 M5
5.
BIT # TX-30 M6
6.
BIT # TX-45 M10
7.
FLAT BLADE
SCREWDRIVER
3.2 mm
8.
FLAT BLADE
SCREWDRIVER
4 mm
9.
FLAT BLADE
SCREWDRIVER
6 mm
10.
PHILLIPS
SCREWDRIVER
PH1
11.
PHILLIPS
SCREWDRIVER
PH2
12.
PHILLIPS
SCREWDRIVER
PH3
13.
HEX KEY 5 mm (UNBRAKO KEY / ALLEN KEY)
14.
HEX KEY 8 mm (UNBRAKO KEY / ALLEN KEY)
15.
HEX KEY 10 mm (UNBRAKO KEY / ALLEN KEY)
16.
HEX KEY M12
REAR
CASTERS:
130 Nm
(UNBRAKO KEY / ALLEN KEY)
REAR CASTERS
17.
Nut Driver 5 mm
18.
Nut Driver 3/16 inch
19.
Torque Wrench,
Up to 81 Nm
Heavy mechanical parts may need a
specific torque. Each procedure will
indicate the torque needed.
20.
WHEEL CHANGE
KIT
N/A N/A
FC200829
BEVEL EDGED BOARD
WOODEN WEDGE