GE M
EDICAL
S
YSTEMS
D
IRECTION
2392751-100, R
EVISION
3
V
IVID
™ 4 S
ERVICE
M
ANUAL
Chapter 7 - Diagnostics/Troubleshooting
7-15
7-3-4
VME Bus (VME) Diagnostic Tests (for RFT Configuration)
The VME Bus diagnostic test checks the communication on the VME Bus between the IP card, the FEC
and the RFT.
Note:
Before performing the VME Bus test, perform the IMP test, as described in the
Diagnostic Tests (for RFT Configuration)
section, on page 7-13. If the VME Bus test is
performed without first performing this test, and errors are identified, you must perform the IMP
test to ensure that the VME board is the source of the error.
1) Access the
FE Diagnostics
dialog box, as described in the
Accessing the Front End Diagnostic
2) In the
FE Diagnostics
dialog box, trackball to the
VME
tab and press
Select
,
OR
Trackball to the
VME
button in the
Data Flow Map
and press
Select
.
The
VME
tab is displayed, as shown below:
Figure 7-8 VME Tab - FE Diagnostics Dialog Box
Data Flow Map
Test Description Area
Test Area
Comment Area
Tabs
