GE TNX22B, Technical Service Manual

Page: 22 / 45

21
COMPONENT SERVICABILITY
Remove the Fresh Food Door
1. Tape the door shut with making tape.
2. Remove the middle hinge pin with a 7/16" socket.
3. Remove the tape and tilt the door away from the
cabinet.
4. Lift the door straight up to free its bottom socket from
the pin in the bottom hinge bracket.
5. Set the door on a non-abrasive surface with the
outside up.
Reversing the Hardware
1. Remove the base grille by pulling it straight out.
2. Using a T20 Torx driver, remove the bottom hinge
bracket.
3. With a 7/16" rachet, remove the bottom hinge pin,
along with the washer, and replace it on the other side.
4. Again, using a T20 Torx driver, remove the tip-over
foot from the left side and reinstall it on the right side.
5. Install the bottom hinge bracket on the left side.
1. Using needle nose pliers, tightly grip the spring and
unhook it from the bottom rail.
2. Pull the assembly out through the hole in the front rail,
being careful not to drop the spring.
3. Reinsert the assembly on the other side. This is done
by inserting the spring through the large slot in the bottom
rail, so that the end loop is visible through the mounting
hole for the mechanism. Hook this loop on the wheel
mechanism, then mount it in place.
4. Again, tightly grip the spring with the needle nose
pliers and hook it onto the bottom rail.
Transfer Middle Hinge to the Left
1. With a flat head screwdriver, remove the cam riser
from the middle hinge and place it aside.
2. Remove the middle hinge, along with the shim, by
removing three Torx screws.
4. Place shim and middle hinge bracket over the holes at
the middle left side of the cabinet. Insert and tighten 3
screws.
5. Reattach the cam riser to the middle hinge bracket.
Transfer Top Hinge to the Left
Transfer the Spring and Wheel Assembly to
the Left Side
MIDDLE HINGE
CAM RISER
WHEN REMOVING DOORS:
* At the lower left hinge, remove tubing clamp,
loosen nut and pull tubing from coupling
* At upper hinges, disconnect wiring connectors
* Remove hinges with each door to prevent
damage to tubing or wiring.
REASSEMBLY:
* Reinstall doors and tighten all hinge screws
firmly.
* Reconnect wiring connectors and ground
wires.
* Reinstall hinge covers.
* Reinstall tubing into coupling and tighten nuts.
* Reinstall tubing clamp.