Pub. No. 31-30524
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Installation instructions
for your new
• Before you begin—Read these instructions completely and carefully.
• IMPORTANT–Save these instructions for local inspector’s use.
• IMPORTANT–OBSERVE ALL GOVERNING CODES AND ORDINANCES.
• Note to Installer–Be sure to leave these instructions with the Consumer.
• Note to Consumer–Keep these instructions with your Owners Manual for future reference.
Spacemaker™
Dishwasher
If you have a question concerning the installation of this
product, call the GE Answer Center
Consumer Information
Service at 800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged dishwasher,
you should immediately contact your
dealer or builder.
Installation of this dishwasher requires basic mechanical and
electrical skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation is not
covered under the GE Appliance Warranty.
See the back cover
of the Owners Manual for warranty information.
The dishwasher MUST be installed to allow for future removal
from the enclosure if service is required.
MATERIALS YOU WILL NEED:
Materials required:
l
90
°
elbow
(3/8" NPT external thread on one end and
opposite end sized to fit water supply)
l
Thread seal tape
l
UL Listed Wire nuts (3)
For new installations only:
l
Air gap for drain hose, if required
l
Waste tee for house plumbing, if applicable
l
Electrical cable or power cord, if applicable
l
Screw type hose clamps
l
Strain relief for electrical connection
l
Hand shut-off valve (recommended)
l
Water line 3/8" min. copper or 1/2" min. plastic
l
Coupler for extending drain line, if applicable
Electrical Cable
or Power Cord
90
°
Elbow
Strain Relief
Hot Water Line
Thread Seal
Tape
Screw Type Clamps
Wire Nuts
Air
Gap
Waste
Tee
Shut-Off
Valve
Flashlight
Flat Blade Screwdriver
Drill
and Bits
Measuring Tape
Level
Phillips Head
Screwdriver
Tubing
Cutter
Square
Hole
Saw Set
TOOLS YOU WILL NEED:
Tools required:
l
Phillips head and flat blade screwdrivers
l
Adjustable wrench (6")
l
Level
l
Carpenters square
l
Measuring tape
l
Safety glasses
l
Flashlight
For new installations only:
l
Tubing cutter
l
Drill and appropriate bits
l
Hole saw set
Adjustable
Wrench
Safety Glasses
DWG. NO. 206C1559P064
(N.D. 679) 8/00
CAUTION:
PARTS SUPPLIED FOR INSTALLATION:
l
Two Phillips head countertop mounting screws taped to dishwasher
Coupler
Figure V
Step 18
Replace access panel and toekick
Refer to Figure V. Place the toekick against the legs of the
dishwasher. Align the access panel to the dishwasher and
tighten the two access panel screws. Align the toekick and
make sure the bottom edge is against the floor. Insert and
tighten the two toekick attachment screws, making sure the
bottom edge of the toekick stays in contact with the floor.
INSTALLATION INSTRUCTIONS:
continued
Attachment Screws
Access Panel
Tighten 2
Access Panel Screws
T
oekick
Step 19
Literature
l
Be sure to leave complete literature package and installa-
tion instructions with consumer.