for Model
reduce
the risk of fire, electric shock, or injury to persons,
read the
INSTRUCTIONS before operating this appliance.
Model
Load clothes into dryer following
●
Clean lint filter. See below.
Cycle Selector to desired
instructions on page 5. If you do
●
Close door. Door must be closed
cycle and select correct drying time
mix various types of fabrics in your
before dryer will operate.
for load size and type.
load, set the controls for the
Push START button
lighter-weight fabrics and remove
the Controls
to start dryer.
door during
when dry. Reset the controls for the
remaining heavier fabrics.
See the Controls Setting Guide
operation stops the dryer. To
below.
close the door and push START
button again.)
Controls
Guide
I
I
Fabric
Cottons & Linens
Delicate Setting
(up
min.)
min.
min.
Small
Load
Press,
Sheers
Damp
Synthetics &
for
Blends
CYCLE
Fluff
Heat)
10 min.
Plastics,
The times
are to be
followed as a guide. You may find
that best results are obtained for
some of your fabrics by setting
times to either side of these
recommendations.
Clean the lint filter before
every load.
L
SHRINKAGE,
—
KNITS
Clean the lint filter by putting your
and insert the suction hose from a
moistened fingers at one comer of
vacuum cleaner into the opening.
the filter and wiping in a sideways
:
Do not operate the dryer without
motion all the way across to the
the lint filter in
other comer. Periodically remove
.
-
----
_. ..\
●
Relaxation shrinkage
can occur in
fabrics that have been improperly stretched
and elongated by the
When this occurs, garment maybe-pressed back into
shape after each wash and dry cycle.
Progressive or delayed shrinkage is caused when starch or sizing (in some fabrics) is
gradually removed by laundering. Maybe noticed in older garments that have been
laundered many times without previous shrinkage. Treat as for Relaxation Shrinkage above.
●
Shrinkage caused by overheating occurs in certain knit fabrics that have been
shaped. When washing, drying or ironing temperatures exceed the temperatures used to
shape set, shrinkage may occur. This cannot be corrected, but it can be prevented by
warm
writer.