GE r08654v-1, Installation Instructions Manual

Page: 1 / 40

1
Built-In Wall Oven
Installation
Instructions
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Tools Needed
1/8
”
(3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Materials Needed
Strain Relief Clamp
for 1/2
”
conduit
Junction
Box
Wire Nuts
36
”
(91 cm)
of String
31-10647-3
11-07 JR
Parts Included
(Appearance will vary)
Screws For Installation
(8-18 x .750 flat head
Phillips wood screws)
WB07T10578 – Black
WB07T10579 – SS
Optional 27
″
(68.6 cm)
Metal Bottom Trim Assembly
(on some models or can be
purchased separately)
27
”
(68.6 cm) models
JKS10, JKP30, JKP35, JKP55, JKP70, JKP75,
PK916, PK956, ZEK938, ZEK958
30
”
(76.2 cm) models
JTP30, JTP35, JTP55, JTP70, JTP75, PT916,
PT920, PT956, PT960, ZET938, ZET958
30
″
(76.2 cm)
Metal Bottom Trim
Assembly
27
″
(68.6 cm)
Metal Bottom Trim
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com