12
49-1000514 Rev. 1
INSTALLATION INSTRUCTIONS
INSTALLATION SPACE
The beverage center and wine chiller can be a
free-standing model or it can be built in using the
cut-out dimensions below.
The cutout depth should be 24”
The cutout dimensions shown allow for a full
door swing and access to the pull-out racks
ZKHQLQVWDOOHGDVDEXLOWLQLQVWDQGDUG´GHHS
cabinets.
7KHGRRUVKRXOGSURWUXGH´EH\RQGWKH
surrounding cabinets.
,ILQVWDOOLQJEHWZHHQIUDPHOHVVFDELQHWVD´
wide filler strip or side panel may be needed on
hinge side. The filler strip will act as a spacer
between the case and adjacent cabinet door
swing. The width of the opening must include the
filler panels.
NOTE:
The door should protrude
´EH\RQGWKHVXUURXQGLQJFDELQHWV
• The beverage center and wine chiller can be
installed freestanding.
Additional Specifications
$YROW+]RUDPSSRZHUVXSSO\LV
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical
must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
Locate
Outlet
34-1/2"-35"
24"
24" Min.
12" Min.
Product dimensions:
Height: 33-3/4" (85.72 cm)
Width: 23-2/5" (59.44 cm)
'HSWKFP
Cut-out dimensions:
+HLJKW´FPPLQLPXP
Width: 24" (61 cm) minimum
'HSWKFPPLQLPXP
Installation Instructions
23-1/4”
33-3/4”
23-2/5”
1
REMOVE PACKAGING
• Remove all packing material, tape and protective
plastic coverings.
WARNING
Small objects are a choke
KD]DUGIRUFKLOGUHQ5HPRYHDQGGLVFDUGDQ\
parts not used.
2
REMOVE RUBBER PAD AND
SHIPPING BRACKET
• Remove Toekick by removing 3 screws.
GROUNDING THE BEVERAGE
CENTER AND WINE CHILLER
WARNING
Electrical Shock
Hazard.
For personal safety, this appliance
must be properly grounded.
The power cord of this appliance is equipped
with a three-prong (grounding) plug which mates
with a standard three-prong (grounding) wall
UHFHSWDFOHWRPLQLPL]HWKHSRVVLELOLW\RIHOHFWULF
VKRFNKD]DUGIURPWKLVDSSOLDQFH
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
Where a standard 2-prong wall outlet is
encountered, it is your personal responsibility
and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
'212781'(5$1<
&,5&8067$1&(6&87
255(029(7+(7+,5'
*5281'3521*)520
7+(32:(5&25'
'212786($1$'$37(5
3/8*72&211(&77+(
$33/,$1&(72$3521*287/(7
'212786($1(;7(16,21&25':,7+
THIS APPLIANCE.
Screws
Summary of Contents for PVS06B Series
Page 53: ...49 1000514 Rev 1 17 Notas ...
Page 54: ...18 49 1000514 Rev 1 Notas ...
