GE Profile WCCD2050YAC, Technical Service Manual

Page: 19 / 35

18
PUMP
To Service Tub Seal
1. Remove basket as previously shown.
2. Using channel locks, grasp 1 of the four tabs
molded into the top of the seal, and pull the seal
out.
3. Position new seal and seat, tap or push the seal
into place, making sure seal is fully seated.
4. Reverse steps to replace basket.
To Service Remote Pump
1. Remove front panel.
2. Pump is located in lower right front corner of cabi-
net. Disconnect harness connectors, pinch off
blacksump hose to prevent water leakage, remove
external drain hose clamp and hose, and black
sump to pump drain hose clamp and hose.
3. Remove 2- 1/4" hex screws in the front of pump
and lift out pump.
4. Reverse steps to replace pump.
(TECH TIP: When a foreign object is removed
from the pump, the front fan blade will rotate
easily.)
MOTOR/CLUTCH
To Service Motor/Clutch
1. Remove front panel, access motor and clutch
from front
2. Loosen (4) 3/8" nuts on leg and platform asm.
3. Move motor towards the center of the platform to
release belt tension, and remove belt.
4. After removing 4 motor mount bolts, rotate trans-
mission to a position that allowsyou enough
clearanceto pull the motor out by moving the bot-
tom forward to allowthe assembly to clear the plat-
form.
5. The clutch is mounted on top of the motor with a
one shot removable clutch spring clip that engages
flats in the motor shaft. To remove the clutch, re-
move the clip and lift the clutch up.
6. Reverse and repeat previous steps to reassemble.
REMOTE PUMP
LOCATION
REMOVE (4) 3/8" NUTS
ON MOTOR TO LEG AND PLATFORM