10 INSTALL GRILLE PANEL
•
Raise the grille panel to the stop position.
•
Remove 4 screws on bottom trim; retain
all screws.
•
Remove bottom trim.
• NOTE:
Stainless steel and acrylic panels are
covered with a protective film. Remove the film
before installing the panel.
•
Slide panel over the metal backer panel and
under the trim.
•
If necessary, tap with a wood block until panel
slips under the top trim piece.
•
Reassemble bottom trim. Tighten screws.
Raise
Grille
Panel
8 SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for anti-tip
security.
The refrigerator must be secured to prevent
tipping.
•
Raise the grille panel to access case trim.
•
Drive a screw through the trim and into
the adjacent cabinet using holes provided.
•
Follow the same procedure on the opposite side.
Drive Screws
Through Case Trim Into
Adjacent Cabinets
Raise Grille Panel
to Stop Position
9 ADJUST DOOR SWING
NOTE:
This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to
a 90° opening.
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION.
•
Open the door to view the bottom hinge.
Note the door stop pin location. The pin is
factory installed in the 130° position.
•
Partially close the door. From above, use
a flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90° position.
90
°
130
°
Hinge
Door
Interior
Installation Instructions
36
