GE Profile PDW8200 Series, Technical Service Manual, Page: 16 / 35

– 14 –
Control Module
To Remove the Control Module:
1. Remove the outer door panel (see Door
Components).
2. Remove the escutcheon keypad assembly
(see Escutcheon Keypad Assembly).
3. Unplug the connectors from the module.
4. Remove the single screw that secures the
module to the right side of inner door panel.
(The screw is located on the outside of the
inner door panel.)
5. Slide the module out.
To Install the Control Manual:
1. Plug connectors into control module.
2. Insert the tabs on the left side of the control
module into the slots on the inner door panel.
3. Install the single screw that secures the
module to the right side of inner door panel.
4. Install the escutcheon keypad assembly (see
Escutcheon Keypad Assembly).
5. Install the door panel (see Door
Components).
Detergent/Rinse Module
The door panel must be removed to access the
detergent/rinse module. See Door Components.
The detergent/rinse module can be activated using
service mode. See Service Mode.
The detergent/rinse module automatically dis-
penses both the detergent and the rinse agent at
the appropriate times. The module is activated 2
times during a wash cycle.
The first time the module is activated (1), the lever
slides up the right-hand path of the connecting rod.
This action releases the detergent cover. When
deactivated (2), the lever returns down the left-
hand path and comes to rest under the notch in
the center of the connecting rod. At the second
activation (3), the lever lifts the connecting rod by
the notch. This action lifts the rinse dispenser
plunger and releases the rinse agent. When
deactivated, the lever returns to its original starting
position.
Cover
latch
Pre-wash
section
Main
wash
section
Cover
Indicator
window
Dispenser cap
Rinse
agent
adjuster
1
2 3
L1 Voltage from J2-6
Single Screw 2 Tabs
Factory Test Cable Port
J2-6
RY WR
1200-2800
DETERGENT MODULE
NO
N
COM
WX
DOOR
INTERLOCK