SERVICING
WARNING –
Label all wires prior
to disconnection when servicing controls. Wiring
errors can cause improper and dangerous
operation after servicing/installation.
For replacement parts and other information,
refer to the Owner’s Manual for servicing phone
numbers.
DUCT CONDITION TEST
Press
DAMP AlERT
and
TEMP
together and don’t
release, then press
POWER
in idle state with no load
in the dryer drum. Your dryer has an innovative
duct blockage monitoring system that
automatically monitors, detects, and alerts you
when blockages occur in your ductwork. The dryer
will show InS in the number display to indicate that
it is in duct dondition testing mode.
Press the START/PAUSE button. The dryer will run
approximately 2 minutes to test for blockages or
restrictions to the air flow in the ductwork.
IMPORTANT:
Do
NOT
interrupt the test cycle!
If you observe “CLg” in the display window you
must clean your exhaust ducting before you
complete installation. Check exhaust ducting for
obstructions or blockages, especially around
turns. Contact a qualified service provider if
necessary.
After testing, press the POWER button to end test.
NOTE: When the dryer is first installed, this test
should be performed to alert you of any existing
problems with the exhaust duct in your home.
However, during normal usage with any cycle,
your dryer keeps automatically detecting duct
blockage and displays “CLg” in blocked condition.
4
Installation Instructions
31
LEVEL THE DRYER
Stand the dryer near the final location. Place
a level against the side and bottom of the dryer
door frame and use the four leveling legs to level
your dryer.
Lower
Raise
PLUG IN DRYER
Ensure proper
ground exists
before use.
1
FINAL SETUP
2
DRYER STARTUP
Press the
POWER
button.
NOTE:
If the dryer has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before pressing
POWER
. Otherwise, the display will not come on.
The dryer is now ready for use.
3
