Handling and Installation 11
1.3 Installation
The
PMC
module
is
now
ready
for
installation.
Installation
is
done
generically
as
with
the
commercial
versions
of
the
card.
Follow
any
specific
procedures
recommended
by
the
manufacturer
of
the
chassis
used.
Perform
the
following
steps:
1.
Turn
all
system
power
OFF.
2.
Remove
the
host
board
from
the
chassis
(if
currently
installed).
3.
Locate
the
PMC
connectors
on
the
host
board.
4.
Carefully
plug
the
PMC
module
into
the
mating
connectors
on
the
host’s
printed
circuit
board.
5.
Make
sure
the
PMC
module
is
seated
properly
into
the
common
mezzanine
card
(CMC)
connectors
on
the
host.
6.
Use
screws
to
fasten
PMC
to
the
host
CMC.
7.
Remove
the
four
screws
from
the
bottom
of
the
stand
‐
offs
of
the
PMC.
8.
Line
‐
up
the
J1
and
J2
connectors
on
the
host
CMC
to
the
J1
and
J2
connectors
on
the
PMC.
9.
Ensure
all
connectors
are
properly
aligned
before
pushing
the
connectors
together.
10.
Use
the
four
screws
to
connect
the
PMC
stand
‐
offs
to
the
host
CMC.
11.
The
chassis
may
now
be
powered
up.
Refer
to
the
illustrated
drawing
below:
Figure 1-1 Installation of PMC Module
