– 40 –
Oven Door Hinge Receiver
To remove the hinge receiver on PHS925:
1. Remove the side panel. (See
Left
Side Panel
or
Right Side Panel
.)
Note:
In the following step,
the procedures to
remove the top brace from the left side or right side
of the range are similar.
2. Remove the top brace. (See
Bake Element
, follow
steps 3-10.)
3. Remove the induction module air inlet vent, (left
side only). (See
Bake Element.
)
4. Remove the cooling fan (right side only). (See
Cooling Fan and FAD (Fan Apparency Device)
.
)
5. Remove the two 1/4-in. hex-head screws and
the cooling blower support, (right side only).
Note:
Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
Right side hinge receiver shown
Hinge
Receiver
Lower Heat Shield
6. Lift and separate the induction module air inlet
vent (left side) or the cooling blower support
(right side) from the air tunnel. Unhook the
bottom of the air tunnel from the range frame.
7. Move the lower heat shield to the back of the
range, tuck the insulation, and then remove the
two T-20 screws that attach the hinge receiver
to the frame.
To remove the lower oven door hinge receiver on
PS978:
1. Remove the side panel. (See
Left
Side Panel
or
Right Side Panel
.)
2. Remove the two T-15 torx screws that attach
the hinge receiver to the frame.
To remove the upper oven door hinge receiver on
PS978:
1. Remove the side panel. (See
Left
Side Panel
or
Right Side Panel
.)
2. Extend hinge as shown below and remove the
two T-15 torx screws that attach the hinge
receiver to the frame.
3. Pull hinge receiver toward the back of the range.
