GE PDS22xxP series, Technical Service Manual, Page: 17 / 30

– 17 –
10. Pull the front edge of the plastic support
housing away from the side wall. Pull the
housing forward to disengage the rear tabs.
Note:
The plastic housing may be tight against
the side wall, and the tabs may be foamed in
place. Some force may be required to remove it.
11. To remove the guide rails from the plastic
support housing, lift the tab on the back side of
the housing with a small flathead screwdriver.
Freezer Drawer Shim
If the drawer is not sealing correctly and the gasket
is not damaged, the door alignment can be
adjusted.
Remove the Phillips screws holding the rail
connector to the drawer front. Using the necessary
number of stainless steel washers, shim the
drawer to provide the correct alignment.
Door Gaskets
The door gaskets are fitted tightly into the door
channel. They should not be removed unless they
need to be replaced.
Note:
When replacing a gasket, a wide blade
screw driver may be necessary to remove the
gasket.
Drawer Front
Rail Connector
Washer
Gasket
Channel
Pull Out