43
Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting
T
ips
Consumer Support
Problem
Possible Causes
What To Do
Control signals after
You forgot to enter a
•
Touch the
BAKE
pad and desired temperature or
entering cooking time
bake temperature or
the
SELF CLEAN LO/STD
pad and desired clean time.
or start time
cleaning time.
Display goes blank
A fuse in your home may
•
Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the
•
See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BROIL HI/LO
and
BAKE
pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
“Probe” appears in
This is reminding you to
•
Enter a probe temperature.
the display
enter a probe temperature
after plugging in the probe.
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the
OFF
pad, setting the clock
and resetting any cooking function.
Steam from the vent
When using the convection
•
This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
“Burning” or “oily”
This is normal in a new oven
•
To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time.
minimum of 3 hours. See the
Using the self-cleaning
the vent
oven section.
Strong odor
An odor from the insulation
•
This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
The words
“CLOSE DOOR”
flashes or scrolls in the
display
This is a normal condition.
The “CLOSE DOOR” is a
reminder message to keep the
oven door closed during broil
mode
•
This is normal. Keep oven door closed during broil
mode
Fan noise
A cooling fan or a convection
•
This is normal. The cooling fan will turn off and
fan (depending on the
on to cool internal parts. It may run after the oven is
function you are using) may
turned OFF. The convection fan will cycle on and off
automatically turn on and off.
until the function is over or the door is opened.
Before you call for service…
www.GEAppliances.ca
