Oven Light Bulbs
NOTE:
The glass cover should be
removed only when cold. Wearing latex
gloves may offer a better grip.
CAUTION
:
Before replacing your
oven light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
For your safety, do not touch a hot bulb
with bare hands or a damp cloth.
To remove:
Turn the glass cover
counterclockwise 1/4 turn until the
tabs of the glass cover clear the
grooves of the socket.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 130-volt halogen bulb,
not to exceed 50 watts.
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers.
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn to
engage.
For improved lighting inside
the oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
completely cool.
Reconnect electrical power to
the oven.
Bulb
Socket
Tab
Glass cover
Use gloves
or cloth
Receptacle
Receptacle
34
Care and cleaning of the range.
Consumer Support
Troubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Oven Light Replacement
(on some models)
To remove the cover:
To replace the cover:
Do not remove any screws to remove the cover.
Be sure to let the light cover and bulb
cool completely.
Hold a hand under the cover so
it doesn’t fall when relased. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Place it into groove of the lightt
receptacle. Pull wire forward to
the center of the cover until its snaps
into place.
Connect electrical power to the
range.
Replace bulb with a 40-watt
appliance bulb.
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is reengaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do
not use any sharp items to remove the
film. Remove all of the film before using
the appliance for the first time.
To assure no damage is done to the
finish of the product, the safest way to
remove the adhesive from packaging tape
on new appliances is an application of a
household liquid dishwashing detergent.
Apply with a soft cloth and allow to soak.
NOTE:
The adhesive must be removed from all
parts. It cannot be removed if it is baked on.
