– 19 –
Control Panel Assembly
Control Panel
The controls for the oven system consist of a key
panel touch fi lm on glass assembly and a main logic
board with its model select resistor plug located in
the control panel.
The controls for the cooktop elements consist of
two burner touch boards connected to and working
through the main logic board.
The main logic board is connected via the LIN serial
wire to the Relay Power Supply Board (RPSM Main)
located on the back of the range, along with a
second relay board (RPSM Aux).
There is also an RTD oven sensor and motor door
lock assembly with position switches.
Cooktop elements are controlled by relays found
exclusively on the RPSM Aux Board. (See
Wiring
Diagram
.)
No relay boards or line voltages are brought to the
control panel.
To remove the control panel:
Pull the range out approximately 6 inches from
1.
the wall.
Remove the six 1/4-in. hex-head screws that
2.
hold the top of the rear panel to the range.
Remove the ground screw.
3.
Rear View
6. Grasp the control panel and pull the bottom out,
then lift the panel off the top 2 screws.
7. Place the control panel in the service position.
Service Position
Ground Screw
5. Using a stubby or offset Phillips-head
screwdriver, remove the 2 inverted screws that
attach the bottom of the control panel to the
range.
4. Place a protective cover on the main top of the
oven.
