GE PanaFlow HT, User Manual

Page: 43 / 163

PanaFlow HT User’s Manual 33
Chapter 3. Initial Setup and Programming
3.4.3 Changing Measurement Type or Value for Totalizer Screens
The totalizer screen appears similar to Figure 24 below.
Figure 24: The Totalizer Screen
To change the number of decimal places in the value of a totalizer screen:
From the display screen, press either the [

] or [

] buttons until the value is
highlighted
Once the value is highlighted, press
[

]
to open the
Display/Decimal
option.
Use the [

] and [

] buttons to scroll to the
appropriate value. (Available options include 0, 1, 2, 3, 4, and Sci (Scientific
Notation). Press [

] t
o select the value, and then [

] again to confirm the selection or
[

] t
o cancel the selection.
Total m^3
Fwd Batch 0.00
E0
Rev Batch 0.00
Totalizer
Reset Totalizer
Error Code
Values
Measurement Type
Start/Stop Totalizer
Totalizer Units
(See Section 3.5)
Total m^3
Fwd Batch 0.00
E0
Rev Batch 0.00
Total m^3
Fwd Batch 0.00
E0
Rev Batch 0.00
Display/Decimal
0
1
2
3
4