NX-148E LCD Code Pad Installation and Setup Manual
7
5. Enrolling
For supervision purposes, the NetworX control panel has the ability to automatically find and store in its
memory the presence of all code pads, zone expanders, wireless receivers, and any other module
connected to the data terminal. This allows these modules to be supervised by the control panel.
Note: All modules should be connected and set to unique addresses prior to enrolling modules. To enroll
the modules, enter the program mode of the NetworX control panel. When the program mode is exited,
the control will enroll the devices. The enrolling process takes about 12 seconds, during which time the
‘Service Required’ will be displayed. Once a module is enrolled, if it is not detected by the control, the
‘Service Required’ will be displayed.
6. Programming the Code Pads
This section describes how to program the address and area of each code pad, as well as the available options.
The code pad address allows the control panel to supervise all code pads and report code pad and line failures.
Factory Defaults:
Master Code:
when using a 4-digit code, or
for a 6-digit code
Go To Program code:
when using a 4-digit code, or
for a 6-digit code
6a. Using the Function Menu
Action
Result
Tip: If you know the function numbers
simply press
[ function number].
Accesses the Function menu.
The display will begin scrolling though available
functions. (See Table 6-1.)
(
example only
)
Press the number(s) for the desired function.
Displays the next menu item.
#
Exits the function menu.
Select an Option
Press
for help
These are samples of the displays that will scroll automatically
in the function menu.
Table 6-1 provides a list of the function menu items, as well as
page references for further instructions.
Select an Option
= Zone Review
