Care and Cleaning
Stainless Steel Hood
6
For your
safety
Before servicing or cleaning the unit, switch
power off at the service panel and lock the
service panel to prevent power from being
switched on accidentally. If the service panel
cannot be locked, fasten a tag or prominent
warning label to the panel.
Light bulbs
To change the light bulbs:
1.
Remove the trim ring by turning it
counterclockwise.
2.
Grasp the bulb on the edges and pull it
straight out.
3.
Replace with the same size bulb.
These 12 volt 20 watt halogen bulbs are
available at specialty lighting stores. Ask for GE
bulb or equivalent: Q20 MR16/FL 40°–BAB.
Metal
grease
filter
Clean the grease filter after 30 hours of “on”
time. A signal light will alert you when 30 hours
has passed.
Remove the grease filters and wash them either
by hand or in the dishwasher using non-abrasive
soap.
To clean, swish the filters in hot soapy water or
wash them in the dishwasher. Do not use abrasive
cleansers.
For proper operation, be sure to use the lower set
of filter holders.
Hood
surfaces
To clean the hood surface use hot soapy water,
then rinse and dry.
For greasy soil use an all-purpose cleaning spray
such as Fantastik® brand or Formula 409® brand.
For hard to clean soil use a stainless steel cleaner
such as Bon-Ami®, Cameo® or Barkeepers
Friend®. Always scrub lightly and with the grain.
Do not use steel wool pads or other abrasive
cleaners. They will scratch the surface.
Note: To remove
filters push them
back and down
using the knob.