GE Monogram ZIBI240, Owner'S Manual

Page: 9 / 20

9
Controls and Features
Bar Refrigerator with Icemaker
Automatic
icemaker
The icemaker will produce seven cubes
per cycle—approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the bar refrigerator with icemaker is
operated before the water connection is
made to the water valve, set the icemaker
power switch to
O (off) .
When the unit has been connected to
the water supply, set the icemaker power
switch to
I (on) . The green light will
come on.
The icemaker will fill with water when it
cools to 15°F (–10°C). A newly installed
bar refrigerator with icemaker may take
12 to 24 hours to begin making ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes
will become cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker,
the green power light will blink. To
correct this, set the icemaker power switch
to
O (off) and remove the cubes. Set the
icemaker power switch to I (on) to restart
the icemaker.
After the icemaker has been turned on
again, there will be a delay of about 45
minutes before the icemaker resumes
operations.
NOTE: In homes with lower-than-average
water pressure, you may hear the icemaker
cycle multiple times when making one
batch of ice.
Icemaker
Feeler Arm
Power Switch
Green
Power Light
Ice storage
bin
To remove, pull the icemaker drawer fully
open and remove the transportable ice
storage bin by lifting up and out.
NOTE: Ice can fall behind the ice storage
bin. Prior to replacing the bin, check for
any fallen ice.
If the ice storage bin is removed from
the refrigerator for an extended period of
time, we recommend setting the icemaker
power switch to
O (off).
To replace, grasp the side of the right side
of the bin with the higher edge so that the
angled side is against the drawer front.
Lower the bin into place and close the
drawer.
CAUTION: Failure to install properly
could cause potential damage to the
icemaker.
The ice storage bin is dishwasher safe, top
rack only.