2
Contents
Design Information
Models Available ......................................................... 3
Dimensions and Clearances ..................................... 3
Advance Planning ....................................................... 3
Advance Planning, Installation Options .................. 4
Tools and Materials Required ................................... 4
Installation Preparation
Cut the Opening ........................................................... 5
Power Supply Locations ............................................ 6
Before you begin—Read these instructions completely and carefully.
IMPORTANT:
Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER:
Be sure to leave these instructions with the Consumer.
NOTE TO CONSUMER:
Keep these instructions with your Owners Manual
for future reference.
For Monogram local service in your area, call
1.800.444.1845.
For Monogram service in Canada, call
1.888.880.3030.
For Monogram Parts and Accessories, call
1.800.626.2002.
Proper installation is the responsibility of the
installer. Product failure due to improper
installation is not covered under the GE
Appliance Warranty. See the Owners Manual
for warranty information.
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
2. Don’t touch electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
FOR YOUR SAFETY
Do not store or use combustible materials,
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
appliance.
Natural Gas Installation Code, CAN/CGA-
B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local
codes where applicable.
• This cooktop has been design-certified by
the American Gas Association according to
ANSI Z21.1, latest edition and Canadian Gas
Association according to CAN/CGA-1.1
latest edition.
• Your cooktop must be electrically grounded
in accordance with local codes or, in the
absence of local codes, in accordance with
the National Electrical Code (ANSI/NFPA
70, latest edition). In Canada, electrical
grounding must be in accordance with the
current CSA C22.1 Canadian Electrical Code
Part 1 and/or local codes.
• Installation of this cooktop must conform
with local codes, or in the absence of local
codes, with the National Fuel Gas Code,
ANSI Z223.1, latest edition. In Canada,
installation must conform with the current
Cet appareil doit être correctement mis à la terre. Voir << Alimentation
électrique >> à la page 6.
Installation
Install Cooktop ............................................................. 7
Install Pressure Regulator ......................................... 7
Connect Electrical ....................................................... 8
Assemble Burners, Check Ignition .......................... 8
Installation Option
Installation with Downdraft Vent ............................. 9
Installation with Warming Drawer ......................... 10
Installation with Single Oven .................................. 11
WARNING
This appliance must be properly grounded and with correct polarity.
See “Power Supply”, page 6.
ATTENTION
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber or gas fitter.
• When using ball type gas shut off valves, they shall be T-handle type.
• A flexible gas connector, when used, must not exceed 3 feet.
