GE Monogram ZGG420LBPSS, Owner'S Manual

Page: 25 / 36

Infrared
sear
burner
(on some
models)
After each use, it is important to operate the
burner on HI for 5 minutes with the hood open
to burn away any food particles or drippings.
Some ash may accumulate on the burner surface
over time. Occasionally brush, blow or vacuum
the debris from the surface of the burner. Only
perform this operation when the burner is
completely cool.
NOTICE: To prevent damage to the burner:
• Always make sure that the protective screen
is properly in place on the infrared burner.
• Never allow water to contact the infrared
burner.
Cooktop
burner
grates
(on some
models)
The enameled cast-iron burner grates should be
cleaned regularly.
Wash them in hot soapy water, rinse and dry
thoroughly.
The grates can also be cleaned inside an oven
during a self-clean cycle, or in a dishwasher. The
frames may be cleaned by hand or in
the dishwasher.
Although they are durable, the grates may dull
over time, regardless of the best care you can
give them. This is due to their continual exposure
to high temperatures. Do not operate a burner for an extended
period of time without cookware on the grate.
The finish on the grate may chip without
cookware to absorb the heat.
For stability, the frames have rubber pads on
each corner. During cleaning and use, be careful
not to damage or snag rubber pads.
Grates (reversible
for wok cooking)
Frame
Pads
Infrared sear burner
with protective screen
Grill
light(s) CAUTION:
Allow the grill and light
assembly to cool completely before replacing.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
Each grill is equipped with a halogen light(s)
located above the warming shelf.
The light assembly consists of a removable glass
light cover and a locking clip.
To remove:
1. Remove the light cover by pulling its right
edge down.
NOTE: The locking clip may fall
from the light cover. It will need to be
replaced properly.
2. Using gloves or a dry cloth, remove the
burned-out bulb by pulling it straight out.
To replace
Use a new 12-volt halogen bulb, with G4 base,
not to exceed 10 watts. IMPORTANT: Higher
wattage bulbs will blow the fuse. See the
Fuse
Replacement section.
Replacement bulbs may be purchased by calling
800.626.2002. Order Part Number WB08X10060.
1. Using gloves or a dry cloth, remove bulb from
its packaging. Do not touch bulb with bare
fingers. Push bulb straight into receptacle all
the way.
2. Place left edge of cover under retaining tab.
Roll right side up making sure that the clip
seats in place.
NOTE: If the locking clip fell
from the cover, hold it in place on the cover
while replacing.
Cover must always be in place when using grill.
Clean the cover frequently using a wet cloth.
This should be done when the grill is completely
cool.
25
Locking clip
Retaining tab