Installation Preparation
Digital Radiant Cooktop
4
Tools &
Materials
Required
• Drill and appropriate bits
• Electric or hand drill
• Pencil
• Ruler
• Carpenters square
• Hand or saber saw
• Flat-blade screwdriver
• Wire strippers
• 120/240 volt or 120/208 volt junction box.
• Electrical cable, 3-conductor or 4 conductor wire, as required
by local codes.
Note:
Do not use an extension
cord with this appliance.
CAUTION
Warning, for
Personal Safety:
Remove house
fuse or open
circuit breaker
WARNING
before beginning installa-
tion.
Do not use an extension
cord or adapter plug with
this appliance. Follow
National electrical codes
or prevailing local codes
and ordinances.
Electrical
Location
This cooktop operates on 240 or 208 volts,
60 Hz, power supply and requires an indi-
vidual, properly-grounded branch circuit,
protected by 40 amp fuse or circuit breaker.
Install the junction box within reach of the
power cable:
– On the rear wall of the cabinet opening.
– At least 16" below the countertop.
• Connect house wiring to junction box in
accordance with local codes.
• Power is located on the bottom at the
center rear.
CAUTION
WARNING
Warning:
The improper connec-
tion of the equipment-grounding
conductor can result in a risk of
electric shock. Check with a
qualified electrician or service
representative if you are in doubt whether
the appliance is properly grounded.
Base
Cabinet
Heat
Clearances
IMPORTANT:
Control Housing Air Flow Provision
The control system is fan cooled during usage.
Installation into a cabinet must not block the
cooling air flow. Review illustrations carefully
before cutting the countertop to insure that
adequate space for the cooktop and clearances
for air space is available.
• Standoffs are positioned along the sides of
the cooktop. These standoffs provide a 1/4"
air gap between the countertop/cabinet and
the cooktop chassis.
DO NOT ATTEMPT TO REMOVE THE
STANDOFFS.
• Maintain 15"min. clearance below cooktop
bottom to any horizontal surface such as a
full depth cabinet shelf.
Air
Outlet
Air Intake
Air Intake
Standoffs