4
Installation
Automatic Icemaker
Advance
Planning
IMPORTANT - (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
Do not use an extension cord or adapter plug
with this appliance. Follow National electrical
codes or prevailing local codes and ordi-
nances.
This ice machine must be supplied with 115V,
60Hz, and connected to an individual,
properly grounded branch circuit, and
protected by a 15 or 20 amp circuit breaker or
time delay fuse.
Power
Supply
Choose the location:
• The ice machine must be installed in an
area protected from the elements, such as
wind, rain, water spray or drip. The area
should be ventilated with temperatures
above 55
°
F (13
°
C) and below 110
°
F (43
°
C).
Best results are obtained between 70
°
F
(21
°
C) and 90
°
F (32
°
C).
• The ice machine may be closed in on the
top and three sides as long as the front is
unobstructed for air circulation and proper
operation.
– Installation should be such that the ice
machine can be moved forward for servic-
ing, if necessary.
– The bottom grille on the front must be
unobstructed to provide proper air flow.
Before you begin:
1.
If a custom panel is to be installed, follow
the instructions shown on page 9.
– Order ZIP75 (black or white) panel kit.
– Order the custom panel from the cabinet
manufacturer.
IMPORTANT: (Please read carefully).
The power cord of this
appliance is equipped with a
three-prong (grounding)
plug that mates with a
standard three-prong grounding wall recep-
tacle to minimize the possibility of electric
shock. The customer should have the wall
receptacle and circuit checked by a qualified
electrician to make sure the receptacle is
properly grounded and has the correct
polarity.
• Where a standard two-prong wall receptacle
is encountered, it is the personal responsibil-
ity and obligation of the customer to have it
replaced with a properly grounded three-
prong wall receptacle.
Do not, under any circumstances, cut or
remove the third (ground) prong from the
power cord.
DO NOT USE AN EXTENSION CORD.
11-1/2"
9"
Electrical Supply Should
Enter From Back Wall
In Shaded Area.
3"
28-1/2"
CAUTION
Å cause de son poids élevé, IL FAUT DEUX
PERSONNES POUR D´PLACER ET IN-
STALLER CE DISTRIBUTEUR DE GLACE.
Due to excessive weight, TWO PEOPLE
ARE REQUIRED TO MOVE AND INSTALL
THIS ICE MACHINE.
PRUDENCE
– Secure the custom panel onto the ice
machine.
2.
Determine a method of drainage. If a floor
drain is to be installed, the drain must be
accurately located. The installation of a
custom door panel will affect the drain
location. See page 7 to determine the exact
location of the floor drain, front to back,
with or without a custom door panel.
– A drain pump kit, ZPK1 is available and will
not interfere with placement of the ice
machine.
3.
The door swing is reversible. If desired,
change the door swing before installation.
4.
Slide the ice machine into the installation
location.
– Open and close the door to be sure there is
no interference.
– Check to be sure the ice machine can be
moved back into the opening, flush with
adjacent cabinetry. There should be no
interference with the floor drain.
• A properly grounded 3-prong receptacle
should be located within reach of the ice
machine’s 66” long power cord. For a built-in
installation, locate the receptacle in the
shaded area shown.
