GE Moisture monitor series 3, Programming Manual

Page: 86 / 99

Programming with PanaView 4-7
March 2008
Testing Recorder Outputs
1.
To test the recorder outputs, click on the
[Test]
button shown in the
“ Recorder Properties ” window (Figure 4-4 on page 4-6). A
message appears: “This will suspend Recorder #[X] on Channel
[X]. Are you sure you want to test this recorder?” Click on
[OK]
to
continue.
2.
The “ Test Recorder” window appears, as shown in Figure 4-5
below. At the top, slide the pointer to the desired percentage of the
full scale recorder range, and click on
[OK]
.
3.
To trim the recorder outputs, scroll the arrows to the right of the
“
Zero” and “ Span” windows up or down until you reach the
desired values, and click on
[OK]
.
Note:
For a complete discussion of testing and trimming recorder
outputs, refer to the sections
Testing the Recorder Outputs and
Trimming the Recorder Outputs in Chapter 2 of the Service
Manual.
The screen returns to the “ Recorder Properties” window.
Figure 4-5: Recorder Test Window