13
DRYER EXHAUST TO BOTTOM
CABINET
WARNING -
BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
(/(&75,&$/ 6833/< 3527(&7 <285
HANDS AND ARMS FROM SHARP EDGES
:+(1:25.,1*,16,'(7+(&$%,1(7
%(685(72:($5*/29(6
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
BEND TAB
UP 45
o
REMOVE
SCREW
AND SAVE.
REMOVE BOTTOM
KNOCKOUT
BOTTOM
EXHAUST
PORTION "A"
FIXING
HOLE
MOBILE OR MANUFACTURED HOME
INSTALLATION
• Installation must conform to the MANUFACTURED HOME
&216758&7,21 6$)(7< 67$1'$5' 7,7/( 3$57
RU ZKHQ VXFK VWDQGDUG LV QRW DSSOLFDEOH ZLWK
$0(5,&$1 1$7,21$/ 67$1'$5' )25 02%,/( +20(
$16,1)3$12%
• The dryer MUST be vented to the outdoors with the
termination securely fastened to the mobile home
VWUXFWXUH6HH(;+$867,1)250$7,21VHFWLRQ
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
7KHYHQWGXFWPDWHULDO0867%(0(7$/
.,7 ' 0867 EH XVHG WR DWWDFK WKH GU\HU
securely to the structure.
• The vent MUST NOT be connected to any other duct,
vent, or chimney.
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• Provide an opening with a free area of at least 25 sq. in.
for introduction of outside air into the dryer room.
• Stacking of a gas dryer is not permitted in a mobile home
or manufactured home.
11
TAB LOCATION
ADDING NEW DUCT
Detach and remove the bottom knockout. Remove the screw
inside the dryer exhaust duct and save. Pull the duct out of the
dryer. Protect sharp edges around the knockout and exhaust
opening with the tape.
Cut the duct as shown and keep portion A.
9"
A
B
FIXING HOLE
5HFRQQHFW WKH FXW SRUWLRQ $ RI WKH GXFW WR WKH EORZHU
KRXVLQJ0DNHVXUHWKDWWKH¿[LQJKROHLVDOLJQHGZLWKWKH
tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW FOR EXHAUST THROUGH
BOTTOM OF CABINET
• Insert 4” elbow through the bottom opening, orient it for
bottom exhaust and connect it to the dryer internal duct.
GARAGE INSTALLATION (IF ALLOWED
%</2&$/&2'(6
'U\HUVLQVWDOOHGLQJDUDJHVPXVWEHHOHYDWHGLQFKHV
FPDERYHWKHÀRRU
CAUTION:
Internal
duct joints must be secured
with tape, otherwise they may
separate and cause a safety
hazard.
• Apply duct tape on the joint between the dryer inter
nal duct and elbow.
DUCT
TAPE
Installation Instructions
