GE moisture.IQ, User Manual

Page: 83 / 182

moisture.IQ User’s Manual 71
Chapter 5. Using the Configuration Menu
5.4.2 Entering User-Defined Tables
To support user-defined functions, the moisture.IQ allows up to six user-defined tables (designated as
Table A
through
Table F
) of non-linear or empirical data. Up to 10
X-Y
pairs can be entered in each table. If a user
function inputs an
X
value, the meter interpolates the corresponding
Y
value and outputs that value to the
function. (The results are extrapolated if the
X
value exceeds the range of the table.)
From the Configuration Menu screen (see Figure 52 on page 59 ), tap the
Tables
button to open a User Table
Setup screen similar to Figure 62 below.
Figure 62: User Table Setup Screen
To set up a user table, complete the following steps:
1. Tap the button at the upper left of the screen to select the table name (
Table A
through
Table F
) from the
drop-down list.
2. The table may contain from 2-10 rows. Use the
Insert Row
and
Delete Row
buttons to configure the
table with the desired number of rows.
3. To enter or edit the data in the table, tap the desired table cell to highlight it in blue. Then, tap the
Edit
Value
button to enter the data for that cell. Repeat this process until all of the data has been entered.
Note:
The
Copy
and
Paste
buttons can be used to copy data from another table into this new table.
4. After all of the data has been entered, tap the
Sort
button to be sure the data points are arranged in
ascending order of
X
values. Then, tap the
Check
button to save the table and tap the
Return
button to
return to the Configuration Menu .