05-2806A01, Rev. L
MDS iNET Series Reference Manual
99
3.4
Using Logged Operation Events
(See “Event Log Menu” on Page 71)
The transceiver’s microprocessor monitors many operational parameters and logs them as various classes
of “events”. If the event is one that affects performance, it is an “alarm”. There are also normal or routine
events such as those marking the rebooting of the system, implementation of parameter changes and
external access to the Management System. Informational events are stored in temporary (RAM) memory
that will be lost in the absence of primary power, and Alarms will be stored in permanent memory (Flash
memory) until cleared by user request. Table 3-4 summarizes these classifications.
These various events are stored in the transceiver’s “Event Log” and can be a valuable aid in troubleshooting
unit problems or detecting attempts at breaching network security.
3.5
Alarm/Event Conditions
(See “View Current Alarms” on Page 73)
Most events, classified as “critical” or Alarms will make the
PWR
LED blink, and will inhibit normal oper-
ation of the transceiver. The LED blinks until the corrective action is completed.
Table 3-4. Event Classifications
Level
Description/Impact
Storage
Informational
Normal operating activities
RAM
Minor
Does not affect unit operation
RAM
Major
Degraded unit performance but
still capable of operation
RAM
Critical
Prevents the unit from operating
Flash
Memory
Table 3-5. Alarm/Event Conditions (Alphabetical Order)
Alarm Condition Reported
Event Log Entry
SNMP Trap
EVENT_50_LIMIT*
Crossed 50% of Eth
Port Rate Limit
rateLimit50(20)
EVENT_75_LIMIT*
Crossed 75% of Eth
Port Rate Limit
rateLimit75(21)
EVENT_100_LIMIT*
Crossed 100% of Eth
Port Rate Limit
rateLimit100(22)
EVENT_ADC
ADC output Railed
adcInput(3)
EVENT_BRIDGE
Network Interface Error
networkInterface(17)
EVENT_ETH_LINK_AP*
AP Ethernet Link
Disconnected
apEthLinkLost(19)
EVENT_FLASH_TEST
Flash Test Failed
--
EVENT_FPGA
FPGA communication
Failed
fpgaCommunication(2)
EVENT_FREQ_CAL
Frequency Not
Calibrated
frequencyCal(7)
EVENT_INIT_ERR
Initialization Error
initializationError(18)
EVENT_IPADDR
*
IP Address Invalid
ipAddressNotSet(4)
EVENT_IPMASK
*
IP Mask Invalid
ipNetmaskNotSet(5)
EVENT_MAC
MAC communication
Failed
macCommunication(1)
Summary of Contents for MDS iNET Series
Page 12: ...x MDS iNET Series Reference Manual 05 2806A01 Rev L...
Page 159: ...05 2806A01 Rev L MDS iNET Series Reference Manual 147 Figure A 22 EDS Wizard Completion Screen...
Page 165: ...05 2806A01 Rev L MDS iNET Series Reference Manual 153 NOTES...
Page 166: ...154 MDS iNET Series Reference Manual 05 2806A01 Rev L NOTES...