Modifications reserved
Page 33/66
OPM_LPS_3UO_80K_M10_1US_V010.doc
User Manual
LP33 Series 80 & 100 UL S1
Code
Message
Meaning
4535
BYPASS LOCKED
Transfer on utility not enabled due to settings of respective
parameters. Contactor K6 is open.
4536
BYPASS FREE
Settings of respective parameters enable bypass transfer
on utility. Contactor K6 can be closed.
4561
LOAD OFF
Key Load Off behind the front door has been pressed, with
the output circuit breaker Q1 closed.
4562
DETOUR ON
The auxiliary contact indicates that manual bypass Q2 has
been closed.
4564
DETOUR OFF
The auxiliary contact indicates that manual bypass Q2 has
been opened.
4567
COMMAND LOAD ON UTILITY
The control unit received a command to transfer the load
on utility.
4568
COMMAND LOAD ON INVERTER
The control unit received a command to transfer the load
on inverter.
4572
NO MORE OVERLOAD
End of the overload condition previously detected with
alarm 4570.
4580
INVERTER AND UTILITY
SYNCHRONIZED
The voltages of inverter and utility bypass are
synchronized.
4582
COMMAND NOT
TO SYNCHRONIZE
Command not to synchronize with utility has been done for:
utility bypass out of tolerance (alarm 4410) or setting
respective parameters.
4583
COMMAND TO SYNCHRONIZE
Command to synchronize with utility has been done for:
utility BP OK (4410) or setting respective parameters.
4600
COMMAND UPS ON
The
ECO Mode
function has been disabled or the
programmed time is expired.
The UPS returns to
VFI
mode supplying the load normally
by inverter.
4601
COMMAND UPS STANDBY
The function
ECO Mode
is enabled, and according to the
time program the UPS will run in
ECO Mode
, supplying the
load normally by utility.
4602
Q1 OPEN
The auxiliary contact indicates that the output switch Q1
has been opened.
4603
Q1 CLOSED
The auxiliary contact indicates that the output switch Q1
has been closed.
4699
BATTERY TEST IMPOSSIBLE
Not possible to start battery test (it is postponed) for:
-
No utility rectifier or bypass
-
Battery not fully charged
-
Load is below 10% or above 80%
4763
REMOTE CONTROL ON
Inverter can be started or shutdown by remote control.
Commands source can be chosen depending on the value
of respective parameter (password required):
0 =
Only local panel
1 =
Only Remote Control
2 =
Both
4764
REMOTE CONTROL OFF
Inverter can be started or shutdown by remote control.
Commands source can be chosen depending on the value
of respective parameter (password required):
0 =
Only local panel
1 =
Only Remote Control
2 =
Both
