GE LOGIQ V2, User Manual

Page: 244 / 381

Safety
4-2
LOGIQ V2/LOGIQ V1
–
User Guide
Direction 5610736-100 Rev. 9
Owner Responsibility
It is the responsibility of the owner to ensure that anyone
operating the system reads and understands this section of the
manual. However, there is no representation that the act of
reading this manual renders the reader qualified to operate,
inspect, test, align, calibrate, troubleshoot, repair or modify the
system. The owner should make certain that only properly
trained, fully-qualified service personnel undertake the
installation, maintenance, troubleshooting, calibration and repair
of the equipment.
The owner of the ultrasound unit should ensure that only
properly trained, fully qualified personnel are authorized to
operate the system. Before authorizing anyone to operate the
system, it should be verified that the person has read, and fully
understands, the operating instructions contained in this
manual. It is advisable to maintain a list of authorized operators.
Should the system fail to operate correctly, or if the unit does not
respond to the commands described in this manual, the
operator should contact the nearest field GE Ultrasound Service
Office.
For information about specific requirements and regulations
applicable to the use of electronic medical equipment, consult
the local, state and federal agencies.
Notice against user modification
Never modify this product, including system components,
software, cables, and so on. User modification may cause safety
hazards and degradation in system performance. All
modification must be done by a GE qualified person.