GE LOGIQ e, Basic Service Manual

Page: 53 / 427

Lockout/Tagout (LOTO) requirements
LOGIQ e – Basic Service Manual 1-29
5461614-100 English Rev. 6
Lockout/Tagout (LOTO)
requirements
Follow Lockout/Tagout requirements by ensuring you are in total
control of the AC power plug at all times during the service
process.
To apply Lockout/Tagout (LOTO):
1. Plan and prepare for shutdown.
2. Shutdown
the equipment.
3. Isolate the equipment.
4. Remove/disconnect the battery, if present.
5. Apply
Lockout/Tagout Devices.
6. Control all stored and residual energy.
7. Verify
isolation.
All potentially hazardous stored or residual energy is relieved.
WARNING
Energy Control and Power Lockout for LOGIQ e.
When servicing parts of the Ultrasound system where there is
exposure to voltage greater than 30 volts:
1. Follow LOCK OUT/TAG OUT procedures.
2. Turn off the breaker.
3. Unplug the Ultrasound system.
4. Maintain control of the Ultrasound system power plug.
5. Wait for at least 30 seconds for capacitors to discharge as
there are no test points to verify isolation.
6. Remove/disconnect the battery, if present.
Ultrasound System components may be energized.