GE KTD-400, User Manual

Page: 16 / 28

KTD-400 Controller Keypad
User Manual
12
Setting electronic autopan limits for domes
To set the electronic autopan limits on dome receivers, first position the dome at the limit. While holding down
the
Zoom in and Zoom out keys, press the arrow keys in the direction of the limit being set.
For example, to set the left limit, move the dome to the position of the desired left limit. While holding down
the
Zoom in and Zoom out keys, press the left arrow.
6. Use the menu in Figure 27 to reverse the pan
and tilt directions for cameras that must be
mounted in an inverted position. Press
1 to
invert or 0 for normal pan/tilt operation. The
next display will appear.
Figure 27. Invert pan/tilt display
7. The next three menus provide choices for
defining the polarity of the output voltage for
the motorized lens connected to the receiver.
a. For zoom direction, press 0 if the lens
requires positive voltage for zoom in and
negative voltage for zoom out .
Press 1 if the opposite is true.
b. For iris direction, press 0 if the lens
requires positive voltage for iris open
and negative voltage for iris close .
Press 1 if the opposite is true.
c. For focus direction, press 0 if the lens
requires positive voltage for focus near ,
and negative voltage for focus far .
Press 1 if the opposite is true.
Figure 28. Zoom, iris, and focus direction displays
8. The clear receiver memory option
( Figure 29 ) will erase all data in the PTZ
receiver’s nonvolatile memory and reload
factory default values.
• If you do not want to clear the memory,
press
0 . This will return you to the
receiver site selection display ( Figure 22
on page 11).
• To clear the PTZ receiver’s memory,
press
1 . This will advance you to the
confirmation display. Press 3 to reload
the PTZ receiver’s memory with factory
default values. If you do not want to
clear the memory, press
0 . This will
return you to the receiver site selection
display (
Figure 22 on page 11).
Figure 29. First clear memory display
INVERT PAN/TILT?
0=NO 1=YES SEQ=NEXT
ZOOM DIRECTION?
0=POS 1=NEG SEQ=NEXT
IRIS DIRECTION?
0=POS 1=NEG SEQ=NEXT
FOCUS DIRECTION?
0=POS 1=NEG SEQ=NEXT
CLR RCVR MEM? 000
0=NO 1=YES SEQ=NEXT
ARE YOU SURE?
0=NO 3=YES SEQ=NEXT