Installation Instructions
3
INSTALL THE BASE PAN
Disconnect the microwave oven from the receptacle.
Remove everything out of the microwave oven,
including packing, temperature probe, Owner’s
Manuals, turntable and turntable support. Remove the
two top plug buttons from the top of the microwave
oven cabinet. Use a knife to pry up the plug buttons,
using care not to scratch the microwave oven. A clear
protective film has been applied to some microwave
ovens and trim kits. If applied, remove the film. Place
the microwave oven on the base pan.
2
Remove 2 front plug buttons
Screw D
A
B
Secure the base pan to the oven by inserting
2 screws (D).
Centered left to right.
INSTALL THE SIDE BRACKET
Install by inserting the tab of
the side bracket into the slot
on the left side of the base
pan, just below the bottom
edge of the oven. Lift the
side bracket up and into
place against the side of the
oven, and align the screw
hole in the side bracket with
the dimple in the oven. Carefully drive one screw (B)
through the side bracket into the side of the oven, using
a screwdriver or power drill. Be sure the side bracket is
tight against the side of the oven.
3
Screw B
WARNING!
If the Side Bracket is removed from the
oven for usage without the trim kit, hazardous situations can
be avoided by reinstalling Screw B into the hole between
the louvers on the side of the oven.
WARNING!
Do not use a drill bit to create the
screw hole. This can damage the oven cavity and create an
unsafe oven.
INSTALL THE BACK COVER
Use the tabs on the bottom of the back cover to place the
back cover on the base pan at the bottom of the open
slot (just below the bottom edge of the oven). Lift the
back cover up and into place against the back surface of
the oven, and align the screw holes. Drive two screws (D)
through the back cover and into the back surface of the
oven.
4
CAUTION!
Start all screws before tightening any
one screw.
Back Surface
of Oven
Screw D
INSTALL THE TOP BRACKET
5
Screw A
Install by placing the top bracket on the front edge of the
top of the oven, and aligning the two screw holes. Drive
two screws (A) through the top bracket, and into the top
of the oven.
INSTALL THE MICROWAVE OVEN
Plug the power
cord into the
wall receptacle.
Slide the
microwave oven
assembly gently
into the cabinet,
using care not to
pinch the power
cord. Be sure to keep the assembly centered as it slides
back to where the tongue of the base support bracket
goes through the rear slots. The top edges of the base
pan should now be centered right to left in the opening.
The base pan and top bracket front flange should be
tight against the cabinet, and the V-notch should match
up with the mark (made in Step 1) on the cabinet.
6
Rear
Slots
1 Ft = 0.3 m
1” = 2.5 cm
