background image

BEFORE YOU BEGIN

1

Installation

Microwave Oven

Instructions

Built-In Trim Kits

Read these instructions  completely and carefully.

IMPORTANT –

Save these instructions

for local inspector’s use.

I

MPORTANT –

Observe all governing

codes and ordinances.

Note to Installer –

Be sure to leave these

instructions with the Consumer.

Note to Consumer –

Keep these instructions for

future reference.

Skill level

Installation of this appliance requires

basic mechanical and electrical skills.

Completion time

1 to 3 hours

Proper installation is the responsibility of the

installer. 

Product failure due to improper installation is not

covered under the Warranty.

• This kit is for use on models:

JEM25WMC, PEM31BMC, PEM31WMC and
PEM31SMC.

• This kit is cUL listed for installation alone or over

any GE/GE Profile single electric wall oven.

• For easier installation and personal safety, we

recommend that two people install this microwave
oven.

• Unplug the microwave oven before attempting

installation of this kit.

WARNING!

This oven must be plugged into a

properly grounded 3-hole, 120 volt receptacle as required
by the National Electrical Code.

PARTS INCLUDED

WARNING!

Before beginning the installation,

switch power off at service panel and lock the service
disconnecting means to prevent power from being
switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, 
to the service panel.

FOR YOUR SAFETY:

Questions? 

Call 1-800-561-3344 

or Visit our Website at: www.

GEAppliances.ca

PARTS

JX827

QUANTITY

Base Pan

Back Cover

Side Bracket

Upper Bracket

Bottom Bracket

Trim Kit

Base Support
Brackets

5 mm x 10 mm
Screw A

4 mm x 10 mm
Screw B

4 mm x 12 mm
Screw C

4 mm x 10 mm
Screw D

4 mm x 16 mm
Screw E

1

1

1

1

1

1

2

2 required

2 extra

1 required

2 extra

4 required

2 extra

10 required

2 extra

4 required

2 extra

Note: 

This kit has extra screws to prevent the

technician from spending extra time locating a
replacement in case they lose one during installation.

Summary of Contents for JX82

Page 1: ...owave oven Unplug the microwave oven before attempting installation of this kit WARNING This oven must be plugged into a properly grounded 3 hole 120 volt receptacle as required by the National Electrical Code PARTS INCLUDED WARNING Before beginning the installation switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally When ...

Page 2: ... sides 1 Overlap 3 Min 1 Overlap Depth WARNING This trim kit uses air flow from the top bottom and sides of the trim frame Blocking the air flow can cause the microwave to function improperly and may cause damage to the microwave Allow a 1 clearance beyond the edge of the trim frame to provide proper air flow FOR INSTALLATION ABOVE A BUILT IN OVEN Microwave oven should be installed on a 3 8 plywoo...

Page 3: ...ons can be avoided by reinstalling Screw B into the hole between the louvers on the side of the oven WARNING Do not use a drill bit to create the screw hole This can damage the oven cavity and create an unsafe oven INSTALL THE BACK COVER Use the tabs on the bottom of the back cover to place the back cover on the base pan at the bottom of the open slot just below the bottom edge of the oven Lift th...

Page 4: ...e oven Open the oven door and locate the 4 screw holes two on the top and two on the bottom edge of the door frame Secure the Trim Kit by driving four screws C through the oven into the Trim Kit 10 A B C CAUTION Start all screws before tightening any one screw Do not overtighten screws since it can cause misalignment of top side strips Screw C REPLACE ANY LOOSE ITEMS Your trim kit is now fully ins...

Reviews: