GE JV690 Use And Care & Installation Manual Download Page 2

OPERATING INSTRUCTIONS 

Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the hood run for a 

few minutes to clean the air after you turn the range off. This will keep the whole kitchen cleaner.

Controls

The hood is “OFF” when the glass visor is pushed 

completely in.

LIGHT–

The light will turn “ON” when the glass visor 

is pulled out approximately 1/2 inch.

BLOWER–

The blower will turn “ON” when the 

drawer is pulled out approximately 1

1

ø

2

 inches.

The blower speed is set using the slide control, 

located to the right of the drawer.

2

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

READ AND SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING

.

SAFETY PRECAUTIONS

CAUTION –

 

FOR GENERAL VENTILATING USE 

ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR 

EXPLOSIVE MATERIALS AND VAPORS.

WARNING – 

TO REDUCE THE RISK OF 

INJURY TO PERSONS IN THE EVENT OF A RANGE TOP 

GREASE FIRE, OBSERVE THE FOLLOWING*:

A.

  SMOTHER FLAMES with a close-fitting lid, cookie 

sheet or metal tray, then turn off the burner. BE 

CAREFUL TO PREVENT BURNS. If the flames do not 

go out immediately, EVACUATE AND CALL THE FIRE 

DEPARTMENT.

B.

 1(9(53,&.83$)/$0,1*3$1³<RXPD\EHEXUQHG

C.

  DO NOT USE WATER, including wet dishcloths or 

WRZHOV³DYLROHQWVWHDPH[SORVLRQZLOOUHVXOW

D.

 8VHDQH[WLQJXLVKHU21/<LI

 

1.

<RXNQRZ\RXKDYHD&ODVV$%&H[WLQJXLVKHU

and you already know how to operate it.

 

2.

 The fire is small and contained in the area   where it 

started.

 

3.

 The fire department is being called.

 

4

 <RXFDQILJKWWKHILUHZLWK\RXUEDFNWRDQH[LW

*  Based on “Kitchen Fire Safety” published by NFPA.

WARNING – 

To reduce the risk of fire, 

electric shock or injury to persons, observe the following:

A.

  Installation work and electrical wiring must be done 

by qualified person(s) in accordance with all applicable 

codes and standards, including fire-rated construction.

B.

  Sufficient air is needed for proper combustion and 

exhausting of gases through the flue (chimney) of fuel 

burning equipment to prevent back drafting. Follow the 

heating equipment manufacturer’s guideline and safety 

standards such as those published by the National 

Fire Protection Association (NFPA), and the American 

Society for Heating, Refrigeration and Air Conditioning 

Engineers (ASHRAE), and the local code authorities. 

When applicable, install any makeup (replacement) 

air system in accordance with local building code 

requirements. Visit 

GEAppliances.com

 for available 

makeup air solutions.

C.

  When cutting or drilling into wall or ceiling, do not 

damage electrical wiring and other hidden utilities.

D.

  Ducted fans must always be vented to the outdoors.

WARNING – 

TO REDUCE THE RISK OF FIRE 

AND TO PROPERLY EXHAUST AIR, BE SURE TO DUCT AIR 

2876,'(³'21279(17(;+$867$,5,17263$&(6

WITHIN WALLS OR CEILINGS OR INTO ATTICS, CRAWL 

SPACES OR GARAGES.

WARNING – 

TO REDUCE THE RISK OF FIRE, 

USE ONLY METAL DUCTWORK.

 

Do not attempt to repair or replace any part of your hood 

unless it is specifically recommended in this guide. All other 

servicing should be referred to a qualified technician.

Summary of Contents for JV690









Reviews: