MINIMUM CLEARANCES
(CONT.)
MINIMUM DIMENSIONS BETWEEN
COOKTOP AND CABINETS OR WALLS
Electrical Outlet Area
(Back of counter in cutout not shown for clarity)
•
The distance from the floor to the top
of the counter must be at least 35-7/8
″
.
The maximum countertop height is 38
″
.
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand
the heat (up to 200°F) generated by the range.
NOTE:
Dimension for Wall to Front of Door
Handle (door closed).
*28
″
FOR MODELS – JSP26, JSS26, JSC26,
JSS16, RS734, RS504
**28-1/2
″
FOR MODELS – JSP39, JSP38, JSP31,
JSP28, RS744, RS622, JS960, JSP40, JSP34
3
3
Installation Instructions
MINIMUM CLEARANCES
•
The distance from the floor to the top
of the counter must be at least 35-7/8
″
.
The maximum counter height is 38
″
.
•
30
″
ranges conform to U.L. requirements
for 0
″
spacing from vertical walls above
countertops. However, some kitchen cabinet
finishes can be damaged by heat from the
range surface elements. Where varnished
wood or plastic film finishes are used,
a minimum clearance of 6
″
must be
maintained.
•
For listed over-the-range microwave
ovens, the microwave ovens can be
installed above the cooktop as per
manufacturer’s installation instructions.
•
The range may be placed with 0
″
clearance
(flush) at the back wall and side walls if the
range side trims extend beyond the cabinet
fronts at least 1/4
″
.
•
See Figures 1 and 2 for all rough-in and
spacing dimensions. These dimensions
must be met for safe use of your range.
The location of the electrical outlet may
be changed as needed, but electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is
in the suggested location (remove lower
drawer).
3
ANTI-TIP DEVICE INSTALLATION
(CONT.)
Slip the nearest link of the chain onto the
bracket. Pull to make sure it is as snug as
possible.
Slide the range all the way back. It is
normal to have some slack in the chain,
but it should not be excessive.
I
H
2
0”
18” Min.
30” Min.
0”
6”
Min.
6”
4
1
⁄
2
”
2
1
⁄
4
”
30”
36”
30”
Acceptable
electrical
outlet area.
Backguard (some models)
Mainback
Bracket Optional
Location
Chain
Bracket Factory
Location
28
1
⁄
2
”** Wall to front
of door handle
(door closed) 45”
with door open
Fig. 5
Fig. 6
Fig. 7
28”*
1
⁄
4
”
5”
