To Operate
Lamp Switch
Models: JN327, JV327, JV337
Press for OFF and ON.
Lamp Switch
Model: JV347
Rotate clockwise, first position for NIGHT LIGHT,
second position for BRIGHT LIGHT.
Fan Switch
Models: JN327, JV327, JV337
CENTER position OFF, DOWN position LOW SPEED,
TOP position HIGH SPEED.
Model: JV347
Rotate Clockwise, FIRST position HIGH, SECOND
position MEDIUM, THIRD position LOW.
Care and Cleaning
Replaceable Charcoal Filter—Used in
non-ducted installations only.
Models: JN327, JV347—non-ducted installations only
The charcoal filter cannot be cleaned. It must be
replaced.
DO NOT RINSE OR PLACE THE CHARCOAL
FILTER IN A DISHWASHER.
The efficiency of your hood depends upon a clean filter.
The frequency of filter replacement depends on hood
use and the type of cooking you do. See replacement
guidelines below for your non-ducted model installation.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
When to replace the filter:
JN327 and JV347 (non-ducted installations only)—The
filter should be replaced after 6 to 12 months. Order and
replace with genuine GE part: WB02X10700.
To remove: Pull down on the center of the front edge of
the filter. The filter will then slip out of the retaining tabs
on the back.
To replace: Slip the back edge of the filter into the retaining
tabs and push the front edge up until it snaps in place.
Reusable Metal Grease Filter—Used in
ducted installations only.
Models: JV327, JV337, JV347—ducted installations only
The efficiency of your hood depends on a clean filter.
Frequency of cleaning depends on hood use and the type
of cooking you do. HOWEVER, THE GREASE FILTER
SHOULD BE CLEANED AT LEAST ONCE A MONTH.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
To remove: Pull down on the center of the front edge of
the filter. The filter will then slip out of the retaining tabs
on the back.
To clean: Soak and then agitate it in a hot water and
detergent solution. Light brushing can be used to remove
embedded dirt. Rinse, shake and let it dry before replacing.
To replace: Slip the back edge of the filter into the
retaining tabs and push the front edge up until it snaps
into place.
With careful handling, the metal filter will last for years.
If a new replacement becomes necessary, order the part
from your dealer. Order genuine GE part: WB02X8391.
Hood
Clean grease laden surfaces of the hood frequently.
Use warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF
THE CIRCUIT BREAKER.
2. Remove the filter.
3. Wipe the fan blade and motor with cloth, dampened
only in ammonia and warm water solution.
4. Replace the filter.
5. Reconnect the hood power supply.
CAUTION: Be certain when cleaning the hood
surfaces you do not touch the lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
3
Vents (JN327 & JV347)
Fan switch
Lamp switch