GE JGSP20GER, Use And Care Manual

Page: 14 / 36

OVEN CONTROL, CLOCK AND TIMER
Clock To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a TIME
BAKE or CLEAN cycle.
c1
Step Press the
CLOCK pad.
CLOCK
1 Step
2:
Press
A INCREASE or
DECREASE pad to
set the time of day.
Step 3: Press the CLOCK pad
to start.
Timer To Set the Timer
The timer is an alarm or minute
timer only.
timer does not
control oven operations. The
maximum setting on the timer is
9 hours and
minutes.
1
Step 1: Press the
TIMER pad.
TIMER
Step 2: Press INCREASE or
DECREASE pad to set the amount
of time on timer.
The timer will start automatically
within a few seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds until 1 minute
is reached.
Then it will display minutes
and seconds until 10 minutes
is reached.
After 10 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset Timer To Cancel Timer Power Outage?
Press TIMER pad and then press Press TIMER pad until the word After a power outage, when power
INCREASE or DECREASE pad
“TIMER” quits flashing on the is restored, the display will flash
until the time you want shows on display (about 4 seconds). and time shown will no longer be
the display.
correct-for example, after a
5-minute power interruption the
clock will be 5 minutes slow.
The display flashes until the clock
is reset. All other functions that
were in operation when the power
went out will have to be
programmed again.
Timer Tones Display Messages
The timer tone is three short beeps followed by
If “door” appears on the display, the door is not
1 beep that repeats every six seconds until you press closed. “LOCK” appears on the display, the oven
any operation. If you would like to eliminate the
door is in the locked position. BAKE, BROIL and
repeating beeps, press and hold the CLEAR/OFF pad COOK TIME cannot be set if the door is in the
for 10 seconds.
locked position.
To return the timer tone to the repeating beeps, press
and hold the
pad for 10 seconds.
14