LIGHT THE PILOTS (cont.)
Adjust the Surface Burner Pilots if Necessary
1.
Raise the cooktop.
2.
Locate the pilot adjustment screw. It can
be accessed through the small hole near
the center of the manifold panel.
3.
To adjust, use a blade-type screwdriver
with a shaft diameter of less than or equal
to 3/16". Turn pilot adjustment screw until
pilot flame is 5/16" high. Do not reduce the
flame to less than 5/16" or pilot outage may
occur. A pilot flame burning higher than
recommended may generate soot (carbon
black) on the bottom of your cooktop.
B
5
Light the Oven Pilot
1.
Ensure the top burners are lit before
attempting to light the oven pilot (turn them
off after you have lit the oven pilot).
2.
Remove the oven door. See
Lift-Off Oven
Door
in the
Care and cleaning of range
section.
3.
Remove the oven racks.
C
Light the Oven Pilot (cont.)
4.
Remove the oven bottom. To remove:
•
Remove knurled screws holding down
rear of oven bottom.
•
Grasp oven bottom at finger slots on
each side.
•
Lift rear of oven bottom enough to clear
the lip of range frame; then pull out.
5.
Locate the pilot in the back of the oven
bottom. The pilot is attached to the left side
of the oven burner.
6.
To light the oven pilot, push in and hold the
oven control knob while lighting the pilot
with a long match or match holder. Once
the oven pilot is lit, continue holding the
oven control knob for one minute before
releasing.
No adjustments are required for natural
gas. If the range is connected to LP gas,
contact the person who installed your
range or made the conversion. If pilot
flame does not stay lit, repeat this step.
C
Pilot
38
Installation Instructions
CAUTION
—
Make sure the surface
burner control knobs are in the
OFF
position
before attempting to adjust the pilots.
Oven
bottom
Shield
(on some
models)
Summary of Contents for JGBS14PCDWW
Page 48: ...48...