After a Clean Cycle
When the clean cycle is finished, the word “CLEAN”
After a clean cycle, you may notice some white ash in
will go out in the display and the oven will begin to
the oven. Just wipe it up with a damp cloth. If white
cool. When the oven temperature has fallen below the
spots remain, remove them with a soap-filled steel wool
locking temperature the word “LOCK” goes out and
pad. Be sure to rinse thoroughly with a vinegar and
the door can be opened.
water mixture. These deposits are usually a
residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, the cycle
may be repeated.
How to Delay Start of Cleaning
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day. NOTE: Before beginning, make sure the
oven clock shows the correct time of day.
Quick Reminder—Delay Start for Self-Clean:
1. Prepare the oven for cleaning.
2. Close and latch the oven door.
3. Press the CLEAN pad.
4. Press the INCREASE pad. If you wish to
change preset clean time of 4 hours, touch the
pad until desired
time appears.
5. Press the STOP TIME pad.
Time that appears is 4 hours later than the time of
day. Press the INCREASE pad until the Stop Time
you desire appears in the display. The self-clean
cycle will automatically begin 4 hours before the
Stop Time you select.
For example: Let’s say it’s
and you want the
oven to begin self-cleaning at
after you’re
finished in the kitchen. The oven has been preset to
clean for four hours.
Step 1: Prepare the oven for cleaning.
Step
2:
Close the oven door and slide the latch handle
to the right as far as it will go. Make sure the oven
light is off.
Step 3: Press the CLEAN pad.
CLEAN
Step
4:
Press the INCREASE pad.
A
The oven is set,
Step
5:
Clean Time is preset for 4 hours. You can
change the Clean Time to anywhere between 2 and 4
hours, depending on how dirty the oven is. If a shorter
Clean Time is desired, press the DECREASE pad until
desired Clean Time is displayed.
Step
6: Press the STOP TIME pad.
STOP
“11
appears on display and “STOP
TIME” flashes. The control
TIME
automatically sets
Time by
adding the Clean Time to the time of
day. In this example, the time of
is
and the Clean Time is 4
Adding 4 hours to the time of day
equals 1:00.
Step 7: Change Stop Time from
to 1
by
pressing the INCREASE pad until “1:00” appears
in the display. The words “DELAY CLEAN” will also
appear in the display.
The self-clean cycle will automatically begin at
and finish at 1
The word “ON” will appear on the
display at
When the oven locks, the word “LOCK” will be
displayed and a short time later, the door latch handle
will be locked in position. It will not be possible to
open the oven door until the temperature drops below
the lock temperature.
When the clean cycle is finished, the word “CLEAN”
will go out in the display and the oven will begin to
cool. When the oven temperature has fallen below
the locking temperature the word “LOCK” goes out
and the door can be opened.
Step
8:
When the LOCK light is off, slide the latch
handle to the left as far as it will go and open the door.
Never force the latch handle. Wait until the word
“LOCK” goes out in the display. Forcing the latch
handle may damage the door lock.
(continued next
23