❑
CONVERTING SURFACE BURNERS ON
MODELS EQUIPPED WITH SEALED BURNERS (See
Step 4 if range is equipped with dual burners.)
1. Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base.
burner
straight out.
DO NOT
disconnect the wires from the burner
bases unless the
needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
or 5/16” wrench (depending on the size of
your spuds).
Apply a 3/4” wrench
hex
on the gas inlet tube as a back-up when
removing spud to prevent
aluminum
tube
twisting.
4.
Install orifice spuds
to one of the
following diagrams (see
❑
or
B ),
for
gas or natural gas, depending on which you are
converting to.
❑
Orifice Spuds for Converting to LPGas:
orifice spuds are in a small plastic bag packed
with this Use and Care book.
spuds
have a 2-digit number and the Letter “L” on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
❑
Orifice Spuds for
Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each
spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
next page)
43
Summary of Contents for JGBP25GEN
Page 49: ...49 ...
Page 50: ...NOTES 50 ...
