GE JDS26, Use And Care Manual

Page: 13 / 36

13
OVEN CONTROL, CLOCK AND TIMER
Clock To Set the Clock
The clock must be set for the
automatic oven timing functions
to work properly.
The time of day clock cannot be
changed during Delay Start. (It can
be changed during a regular bake
or broil operation.)
1. Press CLOCK.
2. Press the
INCREASE or
DECREASE
pad to set the
time of day.
If the INCREASE or DECREASE
pad is not pressed within one minute
after you press CLOCK,
the display reverts to the original
setting. If this happens, press
CLOCK and reenter the time of day.
3. Press START. This
enters the time and
starts the clock.
To check the time of day when
the display is showing other
information, simply press
CLOCK. The time of day shows
until another pad is pressed.
START
CLOCK
Timer
You may program the timer to time cooking or other
household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
When the timer reaches “ :00,” the control will beep
3 times followed by one beep every 6 seconds until
KITCHEN TIMER ON/OFF is pressed.
The 6 second tone can be canceled by following the
steps in the Special Features of Your Oven Control
section under Tones at the End of a Timed Cycle.
How to Set the Timer
1. Press KITCHEN TIMER
ON/OFF.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
If you make a mistake, press
KITCHEN TIMER ON/OFF
and begin again.
3. Press START.
After pressing START, “SET”
disappears; this tells you the time is
counting down, although the display does
not change until one minute has passed.
4. When time is up, the oven control
signals until you press KITCHEN
TIMER ON/OFF. Display then shows
the time of day.
NOTE: The minute timer is independent of all the
other functions and it does not control the oven.
The CLEAR/OFF pad does not affect the timer.
ON OFF
KITCHEN
TIMER
START
ON OFF
KITCHEN
TIMER
Power Failure
If a flashing time of day is in the display, you have experienced a power
failure. Reset the clock.
To reset the clock, press CLOCK. Enter the correct time of day by pressing
the INCREASE or DECREASE pad. Press START.
(continued next page)
Featur
es of Y
our Oven Contr
ol
Oven Contr
ol, Clock and T
imer