The clock must be set to the correct time of day for
the automatic oven timing functions to work properly.
The time of day cannot be changed during a Timed
Bake or
cycle.
- -
To Set the Clock
c1
1. Press the CLOCK pad.
CLOCK
n
2. Press the INCREASE or DECREASE
padtosetthetimeof day.
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
c1
1. Press the TIMER pad.
TIMER
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
10 minutes is reached.
After 10 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and 59
minutes is reached.
To Reset Timer
To Cancel Timer
If “TIMER” is showing, press the INCREASE or
Press the TIMER pad while the word “TIMER”
DECREASE pad until the desired time is reached.
is displayed.
If “TIMER” is not showing, press the TIMER pad
first, then follow the instructions above to set
the timer.
End of Cycle Tones
The end of cycle tone is 3short beeps followed by
To return the end of cycle tone to the repeating beeps,
I beep that repeats every 6 seconds until you press
press and hold the CLEAR/OFF pad for 10 seconds.
any operation. If you would like to eliminate the
repeating beeps, press and hold the CLEAR/OFF pad
for 10 seconds.
Power Outage?
Display Messages
After a power outage, when power is restored the
If “door” appears on the display, the oven door is
display will
and time shown will no longer be
opened and needs to be closed. If “LOCK” appears on
correct—for example, after a 5-minute power
the display, the oven door is in the locked position.
interruption the clock will be 5 minutes slow. Display
BAKE, BROIL and COOK TIME cannot be set if the
flashes until clock is reset. All other functions that
door is in the locked position.
were in operation when the power went out will have
to be programmed again.
11
