32
REMOVE STORAGE DRAWER
ON MODELS WITHOUT BAKING
OR WARMING DRAWERS
Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guide.
Remove the drawer.
C
B
A
4
ANTI-TIP DEVICE INSTALLATION
An
Anti-Tip bracket
is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the
Safety
Instructions
and the instructions that fit your
situation before beginning installation.
WARNING —
•
Range must be secured by
Anti-Tip bracket
supplied.
•
If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
•
See instructions to install (supplied with
bracket).
•
Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
2
Installation Instructions
INSTALL THE RANGE
Stop
Typical installation of anti-tip bracket attachment to wall
Bracket
Screw must
enter wood
or metal
Wall plate
LEVEL THE RANGE
Install the oven racks in the oven
and position the range where it will
be installed.
Check for levelness by
placing a spirit level or
a cup, partially filled
with water, on one of
the oven racks. If using
a spirit level, take two
readings—with the level
placed diagonally first in
one direction and then the other.
The front leveling legs can be adjusted
from the bottom and the rear legs can be
adjusted from the top or the bottom.
Use an open-end or adjustable wrench
to adjust the leveling legs until the range
is level.
D
C
B
A
5
Leg
leveler
Lower
range
Raise
range
Spirit level
PREPARE TO LEVEL MODELS WITH
WARMING DRAWERS
Measure the height of your countertop
at the rear of the opening (X).
Adjust two rear leveling legs so that the
rear of the cooktop is at the same height
as the counter (Y).
Slide unit into place.
C
B
A
3
X
Y
Summary of Contents for JCBP62
Page 42: ...42...