GE IC754VKI06MTD, Manual

Page: 26 / 38

Chapter 4 . Installation
26
Qui User’s Manual–November 2013
GFK-2847
■
DHCP (Dynamic Host Configuration Protocol). The network server assigns an IP
address while the Qui is initializing. (You must be connected to the
network).There must be a DHCP server on the connected network for a valid IP
address to be assigned. Contact your network administrator to ensure correct DHCP
server configuration.
■
Manual method. You specify the numeric addresses obtained from your network
administrator for the Qui IP Address, Subnet Mask and Default Gateway (if
applicable).
Note: To save the settings, run the Backup utility.
4.6.3
Serial Port
4.6.3.1 Serial Port Details
Interface: RS-232
Connectors: Euro Terminal (Tyco Electronics 284539-5 or Equivalent)
Pin
Number
Signal
Name
Pin-out
1 TXD
5 1
2 RXD
3 RTS
4 CTS
5 SGND
Mating Connector: (Tyco Electronics 284 510 or Equivalent)
4.6.4
Universal Serial Bus (USB) Ports
4.6.4.1 USB Host Port Details
The Qui has two full-speed USB 2.0 host ports. A variety of third-party USB
peripheral devices are available.
Each connected USB device requires a specific driver. The driver supplied with the
Qui is for optional keyboard or mouse support; other devices require the installation
of custom driver software.
Interface: USB2.0
Number of Ports: Two
Connector: Type-A connector